Dacia SANDERO 2024 - Exceeding the Limit Speed

SPEED LIMITER
3
the vehicle, the 7 warning light ap-
pears in orange.
The "Speed limiter ON" message or,
depending on the vehicle, the
warning light appears on the instru-
ment panel accompanied by dashes to
indicate that the speed limiter function
is operating and waiting to store a limit
speed.
To store the current speed, press the 4
(RES/+) switch or the 3 (SET/˗)switch:
the limit speed replaces the dashes
and, depending on the vehicle, the 6
warning light appears in white.
The minimum speed that can be
stored is 19 mph (30 km/h).
Varying the limit speed
The limit speed may be changed by
pressing repeatedly or holding down:
– the switch 4 (RES/+) to increase the
speed.
– the switch 3 (SET/˗) to reduce the
speed.
Exceeding the limit speed
It is possible to exceed the limit speed
at any moment. To do this, press the
accelerator pedal firmly down beyond
the point of resistance.
While the speed is being exceeded,
the programmed speed displayed on
the instrument panel flashes. Then, re-
lease the accelerator pedal: the speed
limiter function will return as soon as
you reach a speed lower than the
memorised speed.
If the speed limiter is not
available (after several
attempts to activate),
contact an approved
dealer.
Limited speed cannot be maintained
When driving down a steep gradient,
the system may not maintain the
speed limit: the speed limit flashes in
red on the instrument panel and an au-
dible signal warns you at regular inter-
vals.
Putting the function on standby
The speed limiter function is suspend-
ed when you press switch 5 (0). The
limit speed is stored and displayed in
grey on the instrument panel.
Recalling the limit speed
If a speed has been stored, it can be
recalled by pressing the switch 4 .
Driving - 223