EMERGENCY CALL
3
A call always takes place as follows:
– the call is initiated with the emer-
gency services;
– data related to the incident
(manufacturer's plate, time of the call,
last locations, vehicle direction, etc.) is
sent;
– voice communication takes place
with the emergency services;
– if necessary, emergency assistance
is called.
There are two emergency call modes:
– automatic mode;
– Manual mode.
Automatic mode
The emergency call starts automatical-
ly in the event of an accident that has
required the activation of the protective
equipment (seat belt pretensioners,
airbag etc.).
Manual mode
The emergency call can be initiated
by:
– pressing and holding the
2
button
for at least 3 seconds;
or
– pressing the button
2
five times
within 10 seconds.
If the button was pressed by mistake, it
is possible to cancel the call by press-
ing and holding the button
2
for
around two seconds, before the call is
connected to the call centre.
Once a call is established, only the call
centre can end it.
Operating faults
In some cases, the emergency call
may not work (e.g. low battery, etc.).
When the system detects an operating
fault, the warning light
1
appears in
red for over 30 minutes. Consult an
approved dealer as soon as possible.
The system operates with a
dedicated battery. The bat-
tery service life is approxi-
mately 4 years (the
1
warning
light lights up in red to inform
you).
Consult an approved Dealer.
Driving - 239
To Next Page
Loading...
