TRANSPORTING OBJECTS
4
– raise bars
3
and
4
and fit them in
transverse position
5
. To do this, place
the bar
3
(movement
B
) in the front
position, then place the bar
4
(move-
ment
C
) in the rear position.
Note: make sure that bars
3
and
4
are positioned correctly and, depend-
ing on the vehicle, that they comply
with the direction shown on each mark
6
located on the mountings at each
end of the bars.
Maximum weight on each
roof bar: 40 kg evenly dis-
tributed (80 kg on both roof
bars).
– use the tool
7
to tighten the bolts
2
:
markers
D
and
E
located on the tool
are offset (mark
8
);
– tighten the bolts
2
as far as possible
using the tool
7
until markers
D
and
E
located on the tool
7
are parallel (mark
9
);
– re-clip the rotary covers
1
.
Note: bars
3
and
4
are not inter-
changeable.
274 - Your comfort
To Next Page
Loading...
