HEADLIGHTS, LIGHTS: REPLACING BULBS
6
Unclip the connector
6
, remove the
assembly from its housing and take
out the bulb.
Bulb type: H15.
Do not touch the bulb glass. Hold it
by its base.
It is essential to use anti-U.V. 55/15W
bulbs so as not to damage the plastic
on the headlights.
Markthebulb’spositionbeforere-
moval to ensure correct positioning
when replacing.
When the bulb has been changed,
make sure you refit the cover correctly.
Please note when work-
ing close to the engine
that it may be hot. The
engine cooling fan may
also start at any moment. The
label in the engine com-
partment reminds you of this.
Risk of injury.
To comply with current leg-
islation, or as a precaution,
you can obtain an emer-
gency kit from your approved
dealer containing a set of spare
bulbs and fuses.
Any operation on (or
modification to) the elec-
trical system must be
performed by an ap-
proved Dealer since an incorrect
connection might damage the
electrical equipment (harness,
components and in particular the
alternator). In addition, your Deal-
er has all the parts required for fit-
ting these units.
Headlights: vehicles with LED and
halogen headlights
(depending on the vehicle)
The bulbs detailed below can be re-
placed. However, we recommend that
these be replaced by an Approved
Dealer if this proves difficult.
Direction indicator lights
7
Turn the bulb holder
9
a quarter of a
turn to access the bulb.
Bulb type: PY21W.
312 - Practical advice
To Next Page
Loading...
