FRONT SEATS
2
Lift and hold the handle
1
to unlock
the seat. Release the handle at the de-
sired position and make sure that it is
locked.
To raise or lower the seat base
(depending on the vehicle)
Move the lever
2
as many times as
necessary upwards or downwards until
the required position is reached.
To tilt the seatback
Lift handle
3
and tilt the seatback to
the desired position. Release the han-
dle at the desired position and make
sure that it is locked.
Heated seats
(depending on the vehicle)
Ignition on:
– a first press on the switch
4
for the
seat concerned activates the heating
system at maximum power. Both of the
built-in warning lights on the switch
light up;
– a second press decreases the heat-
ing to minimum power. One integrated
warning light is illuminated;
– pressing for the third time turns the
heating off.
The system automatically regulates
the seat temperature. When activated,
it will determine if the seat heating is
necessary or not.
After making adjust-
ments, make sure that
the seatbacks are cor-
rectly locked in place.
For safety reasons,
carry out any adjust-
ments while the vehi-
cle is stationary.
We would advise you not to re-
cline the seatbacks too far to en-
sure that the effectiveness of the
seat belts is not reduced.
Nothing should be placed on the
floor (area in front of the driver) as
these objects may slide under the
pedals during sudden braking ma-
noeuvres, thus obstructing their
use.
Getting to know your vehicle - 45
To Next Page
Loading...
