1.7L 3KW Argyle Kettle Grey
Model No. SDA1820
User Manual
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
Replacing the Filter (2)
Care and Use of Your Kettle
• Ensure the mains plug is removed from the socket outlet before cleaning.
• Do not immerse the kettle or the base in water or any other liquids.
• Wipe the kettle clean with a clean damp cloth.
• Do not use harsh or abrasive scouring pads, powders or cleaners.
• Do not clean any part of the kettle in a dishwasher.
Allow the kettle to boil, switch off and then stand to allow the kettle
to soak for approximately 15 – 20 minutes, (if necessary, adjust the
standing time to the descaling products instructions).
Finally, empty the kettle and refill with fresh clean water and allow
to come to the boil and switch off once more, then again pour the
water away. Your kettle is now descaled and cleaned.
The Filter (2) is located inside the kettle
behind the Spout (1) and is accessible
from inside the kettle when the Lid (3)
is removed.
Remove the Lid (3). Press the catch
down on the Filter (2) and then lift the
out as shown left.
Replace the Filter (2) by pushing it back
inside the kettle behind the Spout (1),
ensuring the catch is clicked back into
place and then replace the Lid (3).
To Next Page
Loading...
