• If the battery compartment does not close securely, stop using the product and
keep away from children.
• If you think batteries may have been swallowed or placed inside any part of the
body, seek immediate medical attention.
Safety Tip –Over
WARNING! This appliance is fitted with a built in safety tip-over switch, if the
appliance is tilted by 30° or more the cut-out is activated and the unit will stop
working. The Display (8) will show the following fault code “E3”. Place the heater to
the upright position and the unit will begin to operate normally.
Safety Cut – Out (Overheat Protection)
WARNING! This appliance is fitted with a built in safety cut-out, that will activate
when the ambient temperature reaches 35°C or above. If the cut-out is activated
the unit will automatically stops working and go into standby until the ambient
temperature has dropped to below 35°C.
Care and Use of your Fan
• Ensure that the fan is not connected to the mains supply before cleaning and if
using heat mode allow to cool.
• Wipe the fan body clean with a clean, soft damp cloth.
• Do not use harsh detergents or abrasives to clean.
• Do not use polishes to clean.
• Do not immerse the fan or its cord in water or any other liquid.
• To prevent dust build-up it is recommended to periodically clean both the Air
Inlet (3) and Air Outlet (1), use a soft bristle brush.
To Next Page
Loading...
Need help?
General
