Heat Mode
• Place the fan & heater on a solid, dry, heat resistant surface.
• Insert the Mains Plug (6) into a socket and switch the socket on (if applicable).
• Touch the Power On/Off Button (12) or press the corresponding
button on the Remote Control (7) – arrowed right, to power up
the fan.
• Touch the Heat Button (9) to switch on heat mode.
• Repeatedly touch the Heat Button (9) to select from:
H1 for Low Heat mode
H2 for Medium Heat mode
H3 for High Heat mode
• Alternatively, if using the Remote Control (7), press the ‘COOL/HOT’
button for heat mode.
Select the desired heat settings on the Remote Control
(7) by pressing the ‘H’ (High Heat), ‘M’ (Medium Heat) or
‘L’ (Low Heat) buttons, arrowed right:
H1 for Low Heat mode
H2 for Medium Heat mode
H3 for High Heat mode
WARNING! The surface of the unit will become hot in heat mode, particularly
around the Air Outlet (1). Allow the unit to cool before cleaning.
Switching off
Touch the Power Button (1) on the unit either the Control Panel
(4) or the corresponding button on the Remote Control (7).
Timer Operation
Whilst the unit is operating, press the or button on the
Remote Control (7) until the desired time the unit is to be on
for is shown on the Display (8).
The timer can be set in hour increments up to 9 hours.
The fan & heater will automatically go into standby mode if left inactive for 20
minutes.
To Next Page
Loading...
Need help?
General
