107
Radio operation
ҮPress power switch 14 to power on
the system.
ҮPress Radio/MIC switch 15 to select
the Radio/MIC operation.
ҮTurn Radio/cassette ON/OFF and
volume knob clockwise to operate
and control the volume, then the
indicator starts displaying and each
lamps of knobs and buttons come
on simultaneously.
ҮPress band select button 7 to select
AM/FM band.
ҮPress seek button 5, then the fre-
quency is automatically increases or
decreases and stops when any
receivable frequency is seeked.
(֪: decrease, ֫ : increase)
ҮKeep pressing the tune button 12,
then the frequency increases or
decreases, when the needed fre-
quency is received, release the but-
ton ֪: decrease, ֫ : increase)
ҮPress present button 13 to receive
the memoried frequency. Also, to
memory any frequencies on preset
buttons, while the needed frequency
is being received, keep pressing
preset buttons more than 2 seconds.
ҮTurn the tone knob 3 to control the
strength of high sound.
ҮTurn th balance knob 4 to balance
the sounds of left and right speak-
ers.
ҮPress loud button 18 to enhance the
low and high sound.
ҮWhen the receiving condition is not
good because of high impedance,
magnetic interference of etc, push
power switch 14, then receiving con-
dition can be enhanced and “LOC”
is displayed in indicator.
Cassette operation
ҮInsert tape into the slot 9, then the
radio stops and tape play backe
starts automatically.
ҮKeep pressing fast rewind/progress
or fast forward/progress button 10,
11 to rewind or forward the tape
fastly.
ҮPress fast rewind/progress and fast
forward/progress buttons 10, 11
together, then the tape play back
direction changes.
ҮPress eject button 6, then the tape
play back is stopped and the tape
is ejected through the tape slot.
ҮTone, balance and loudness controls
are same as radio operation.
MIC operation
ҮInsert mail type jack of microphone
into MIC jack 17.
ҮPress RADIO/MIC switch 15 to
select the Radio/MIC operation.
ҮTurn mic volume knob 16 to control
the volume of MIC sound.
ҮTurn mic tone knob 18 to control the
tone of MIC sound.
Echo operation
ҮTurn echo effect knob 20 to control
the echo stength.
ҮTurn echo speed knob 21 to control
the echo speed.
ҮThe volume and tone controls are
same as MIC operation.
To Next Page
Loading...