7171
Check points (cycle)
Refrigerant cycle
Engine
Control devices
Items
Compressor
Condenser
Evaporator fan
Hi, low pressure switch
Drier
Receiver tank
Others
V–belt
Magnetic clutch
Control panel
Cooling unit
Condenser fan
Evaporator fan
Magnetic clutch
Check point
1. Check for operation.
2. Check for oil level and keep sufficient amount.
1. Clean fin and tube.
2. Check for gas leak and damages.
ҮCheck for operation.
ҮCheck for operation.
ҮReplace desiccant and filters.
ҮCheck for operation.
1. Check for clamping of connected parts.
2. Check for gas leak of connected parts.
3. Check for air filter mat, drain hose and keep clean.
ҮCheck for the tension of V–belt.
ҮCheck for compressor pulley.
1. Check for switch
2. Check for lamps.
3. Check wirings for loosened condition and clamping condition.
4. Check for attaching condition.
ҮCheck for the damages and looseness.
ҮCheck wiring frame for looseness.
ҮCheck terminal for fixing condition.
ҮCheck covered wire for damage.
To Next Page
Loading...