16
NOTE: Before trimming grass, remove the protection cover from the
sharp edge on the guard.
• INSTALLING NYLON LINE CUTTER HEAD
• Install the guard shield on the lower shaft.
• Install the bend cover pressure plate on the guard shield and lock it
tightly with the installation of the guard shield.
• Align the holes on the bending plate with the holes on the lower shaft
and tighten them with screws.
• Fix the lower shaft with a wrench and rotate the grass cutting head
until it is locked.
INSTRUCTIONS FOR USE
Follow these steps to operate the trimmer.
• Plug the trimmer cord into an extension cord approved for outdoor
use. Refer to “Electrical Safety Rules” earlier in this manual.
• Hold the trimmer with your right hand on the trigger handle and your
left hand on the front handle, also the user can carry the carrying
strap around the shoulder.
NOTE: Keep a rm grip with both hands during operation.
• Place the trimmer on the right side of your body with the engine be-
hind and away from your body.
EN
To Next Page
