12
EN
THE BLADE: the blade is made of pressed steel, in order to obtain
a clean work sharpen the blade frequently, around every 25hours of
work. Be sure that the blade is always well balance, introduce a small
iron axle(Ø2 or Ø3 mm) in the central hole of the blade, it should stay
horizontal.
If the blade does not stay horizontal balance it by taking off some metal
on the side, which is down.
YOU MUST ONLY USE THE MANUFACTURER BALDE IT SHOULD
BE REFERENCED AND WEAR THE MANUFACTURER BRAND “SIN-
HABOUR”
To remove the blade, unscrew the screw, O,check the blade support
and change all spare parts if they are worn out or damage.
When reassembling the blade, make sure that the cutting edges face in
the direction of the engine rotation. The blade screw must be torque to
3.7 K· gm (37Nm) with a dynamometric tool.
ONLY USE ORIGINAL SPARE PARTS. SPARE PART OF BAD
QUALITY CAN INVOLVE IMPORTANT DAMAGES TO YOUR LAWN-
MOWER AND BEPREJUDICIAL FOR YOUR SECURITY
To Next Page
Loading...
