19
4. Press UP/－ or DOWN/+ key to set the first code, press SET/STORE/÷ key to confirm. Set the
second code by same way. If PABX code has one digit only, set the second digit to “-”.
¾ Setting Flash time
1. At on-hook state, press SET/STORE/÷ key and UP/－ key three times, LCD displays SET 4
FLASH
2. Press SET/STORE/÷ key again, LCD displays FLASH 4 110
3. Press UP/－ or DOWN/+ key to edit the Flash time to 110, 300, 600 or 1000ms.
4. Press SET/STORE/÷ to confirm.
¾ Setting the LCD contrast
1. At on-hook state, press SET/STORE/÷ key and UP/－ key four times, LCD displays SET 5
LCD. Press SET/STORE/÷ key again, LCD displays LCD 3
2. Press UP/－ or DOWN/+ key to adjust the LCD contrast, total 5 levels can be selected.
3. Press SET/STORE/÷ key to confirm.
Note: Alternatively in on-hook state, press R key continually to adjust the LCD contrast to the
comfortable level, press DEL key to save and quit.
¾ Setting normal alarm clock
1. At on-hook state, press SET/STORE/÷ key and UP/－ key five times, LCD displays SET 6
ALERT
2. Press SET/STORE/÷ key, LCD displays 1 00-00 OFF and the number “1” flashes, press UP/
－ or DOWN/+ key to select the group number from 1~3. Press SET/STORE/÷ key to go into
the alarm time setting.
3. Use the UP/－ or DOWN/+ to adjust the alarm time, and press SET/STORE/÷ key to confirm
every digit.
4. After setting alarm time, the OFF flashes; press the UP/－ or DOWN/+ key to select ON.
5. Press SET/STORE/÷ key to confirm.
6. Set the rest 2 groups normal alarm clock by the same way.
Note: After time runs up to the set alarm time, the phone will send out “DI, DI” sound for 1 minute.
Press any key to stop alarming and return to on-hook state.
The alarm clock is available only when the phone is connected to telephone line.
¾ Setting anti-dialing from parallel phones
1. At on-hook state, press SET/STORE/÷ key and UP/－ key six times, LCD displays SET 7 PPP
2. Press SET/STORE/÷ key to confirm, LCD displays PPP OFF
3. Press UP/－ or DOWN/+ key to select ON.
4. Press SET/STORE/÷ key to confirm, LCD displays a icon.
Note: After setting it to ON, it will not allow making and receiving calls from parallel phones,
otherwise it will send out “di-du” tone. So please set it as OFF if you connect any extension to the
phone, otherwise the extension phone cannot work properly.
To Next Page
Loading...
