25
3. Pick up handset to talk over handset.
4. Or press or HOLD key to quit hold mode and talk at hands-free mode.
LCD BACKLIGHT FUNCTION
The backlight will light on when receiving an incoming call, dialing, pressing any key or in music
hold mode, etc. It will fade off if the telephone is left idle for 6 seconds.
Note: If batteries are not loaded, there will be no LCD backlight.
ADJUST RINGING VOLUME AND HANDSFREE VOLUME
In on-hook state, press VOL key more one times to select the ringing volume, total 4 levels, press
DEL key to save and quit.
In handsfree state, press VOL key more one times to adjust the handsfree speaker volume, total
3 levels.
PAUSE FUNCTION
If dial a number from PABX extension, press PABX number (normally “0” or “9”) + VIP/P/DND key
+ desired number. When redial, need not dial PABX number and VIP/P/DND key, just press
REDIAL/ARD key.
LOCK FUNCTION
Turn the key to yellow point of LOCK, all numbers except 110, 112, 119, 120, 122 and 999 will be
locked.
Turn the key to green point, number led by “0” will be locked.
Turn the key to red point to unlock, all numbers will be allowed to dial.
CALCULATOR FUNCTION
In on/off-hook state, press CAL key, LCD displays 0, the unit is in the calculator state. The unit is available
for “+. -. ×. ÷”. #/= key is used as “=”, the */.key is used as “.”, OUT/× and SET/STORE/÷ are used as
× and ÷ respectively, DOWN/+ key and UP/－ key are used as positive and negative signs respectively.
Eg.1 (10+26) ÷2
1. In on/off-hook state, press CAL key 2. Press (1, 0, +, 2, 6), ÷, 2, #/= keys
2. After calculated, press R key to quit.
Eg.2 0.5×0.6-1
1 In on/off-hook state, press CAL key
2 Press 0, */., 5, ×, 0, */., 6, －, 1, #/= keys
3 After calculated, press R key to quit.
NOTES
Please unplug telephone line and power (if any) when install or replace batteries.
To Next Page
Loading...
Need help?
General
