16
STEP10. Connecting the inlet hose
The dryer must be connected to the cold water faucet using the
new inlet hoses. Do not use old hoses.
1. If space permits, attach the brass female end of the “Y”
connector to the cold water faucet.
2. Turn the cold water faucet off.
3. Attach the straight end of long hose to “Y” connector.
4. Using pliers, tighten the coupling with an additional two-thirds
turn.
5. Attach angled end of long hoses to fill the valve at the bottom
of the dryer’s rear frame. Screw on coupling by hand until it is
seated on fill valve connector.
6. Using pliers, tighten the coupling with an additional two-thirds
turn.
7. Check that the water faucets are on.
8. Check for leaks around “Y” connector, faucets and hoses.
To Next Page
Loading...
