Clearing blockages
Ensure the upright vacuum is turned o and disconnected from the mains
supply before checking for blockages.
The upright vacuum would only become blocked if the cylinder is full
(Beyond the MAX level), the lters are clogged or a large object has been
sucked up.
1. Check the cylinder and empty if necessary.
2. Check the lters, remove any debris or dust and wash if necessary.
3. If the multi tool has been used, detach it from the hose and check for
blockages.
4. Detach the hose from the vacuum by rotating the
white plastic ends and pulling them away from the
vacuum. (see right)
Lay the hose at and look through it to see if there
are any blockages. If there are, use a broom
handle or similar to clear them taking care not to
damage the hose in the process.
5. Check the hose sockets and clear any blockages.
6. Check the brushroll for any hair or thread which
may have become wrapped around the roller. Cut
away with a pair of scissors.
How to store your vacuum
1. Turn o the power at the mains supply and unplug.
2. Place the vacuum in the upright position.
3. Remove the crevice/brush multi tool if last used and place in it’s
holder.
4. Wrap the cord around the upper and lower storage hooks on the back
of the vacuum.
5. Store the vacuum away safely in a dry place.
Tornado F1 Upright Vacuum
FLR00049
User Manual
To Next Page
Loading...
Need help?
General
