14
Quick Reference Guide
3. Soot level full. Regeneration required now (yellow).
The engine derates power and a forced stationary regeneration is
required as soon as safely possible.
4. Soot level full. Service required (red).
The engine derates power and an authorised DAF Service dealer must
service the vehicle.
It is no longer possible to perform a forced stationary regeneration.
Safety checks
Before starting a forced stationary regeneration, make sure that following safety checks
have been performed:
– The vehicle is parked outside with a minimum of 2 metres clear space around the
exhaust outlet.
– The park brake is applied.
– The engine is running at idle speed.
– The vehicle is NOT left unattended.
– The coolant temperature is above 65 degrees.
Performing forced stationary regeneration
When all safety checks have been met,
press the upper side of the DPF switch
(1) once to allow the engine
management system (EMS) to carry out
a self check. Follow the instructions on
the master display.
Press the upper side of the DPF switch
again to start the forced stationary
regeneration process.
NOTE: Prevent any
regeneration action by
switching to 'OFF' (press the
lower side of the DPF switch)
when working inside or when
entering a hazardous area.
DW63299401.book Page 14 Monday, September 4, 2017 3:58 PM
To Next Page
Loading...
Need help?
General
