3
CF65/75/85 series Draining and filling
CLUTCH
6-1
6. DRAINING AND FILLING
6.1 DRAINING AND FILLING, CLUTCH SYSTEM
Hydraulic fluid is toxic and can have
a damaging effect on your health.
Direct or indirect physical contact
should therefore be avoided.
As hydraulic fluid is also a
corrosive fluid, it may damage the
paintwork of the vehicle. Avoid any
contact between hydraulic fluid and
paintwork.
Always use new and clean hydraulic
fluid which has been kept in a
sealed container that meets the
specifications. Hydraulic fluid which
has absorbed water (from the
ambient air) may have an adverse
effect on the operation of the clutch
system.
Avoid any contact with mineral oil.
Even one drop of mineral oil in the
system will damage the seals.
Draining the clutch system
1. Place a tray beneath the clutch servo.
2. Disconnect the steel supply pipe from the
clutch servo and drain the oil from the
reservoir by moving the pedal up and down.
3. Refit the steel supply pipe.
Filling the clutch system
1. Fill the reservoir with the specified fluid and
bleed the system.
V300064
10
ᓻ 200337
https://www.truck-manuals.net/
To Next Page
Loading...
