3
MECHANICAL GEARBOX CONTROL
Inspection and adjustment CF65/75/85 series
2-2
Adjustment, gearbox control LHD/RHD
1. Tilt the cab.
2. Remove the lever from the selector shaft.
3. Position the gear lever exactly in position A.
See “Technical data”.
4. Check that the gearbox is in neutral.
5. Fit the selector shaft lever (4) to the
selector shaft and fit the attachment bolt,
tightening it to the specified torque. See
“Technical data”.
Note:
The torque rod (1) of the gearbox control is
equipped with fixed (non-adjustable) ball
joints. If the torque rod (3) strut has been
fitted correctly and the gear lever is exactly
in position A, the shape of the control rod
(2) will dictate the correct position of the
lever (4) on the selector shaft.
6. Check that all gears can be engaged
without parts coming into contact with each
other.
V300404
A
3
1
2
4
2
ᓻ 0111
https://www.truck-manuals.net/
To Next Page
Loading...
