11.
The causes of disruptions heater
- when the heater heats the water too low, you should:
a) check the mains power supply and remove any causes of voltage drop,
-when the heater heats the water too much, you should:
a)
clean aerator (fut. 16),
b)
clean strainer filter in the left battery connector pipe,
c)
check for obstruction in plumbing before heater,
-when the heater does not work, you should:
a) check whether the water mains water pressure is too low, resulting in
low water flow through the heater,
a) check whether the water mains water pressure is too low, resulting in
low water flow through the heater,
- cause breaks heater is:
a) too low or decreasing the water pressure in the mains supply.
Repair device made only by an authorized service center
AquaDaf.com.
The symbol on the product or packaging indicates that the
waste equipment cannot be treated as general household waste,
and that the end of life shall be handed over to one of the selection
of electrical and electronic equipment, organized by the public
administration.
To Next Page
Loading...
