14
Step 3 Select ports that need to be configured, and then select
Enable
to configure all-port
broadcast storm control function.
You need to configure all the ports in case there might be malfunctions, and the Switch
cannot properly transmit the data.
Figure 3-5 Configure broadcast storm control
Step 4 Click
Save
.
4.6 Long Distance Transmission
You can set port long distance transmission mode. For the standard Ethernet mode, the transmission
speed can become 10 Mbps/250 meters instead of 100 Mbps/100 meters.
Step 1 Select
Port Management
>
Long Distance PoE
on the
System Info
page.
Step 2 Select the checkbox under
Enable
in the corresponding port.
To Next Page
Loading...
