HDCVI Standalone DVR User’s Manual
Check the box here to enable tour function.
Here is for you to adjust transparency. The value ranges from 5 to
120s. The default setup is 5s.
Here you can set window mode and channel group. System can
support 1/4/8/9/16/25/36-window according to device channel
amount.
Here you can set motion detect tour/alarm tour window mode.
System supports 1/8-window now.
5.8.5.2.4 Zero-channel Encoding
The interface is shown as in Figure 5-101.
Figure 5-101
Please refer to the following sheet for detailed information.
This function is disabled by default. Check the box here to enable
this function so that you can control the zero-channel encoding
function at the WEB.
System default setup is H.264. You can set according to device
capability.
The resolution value may vary due to different device capabilities.
Please select from the dropdown list.
The frame rate value may vary due to different device capabilities.
Please select from the dropdown list.
The default setup is 1024Kb/S. The bit rate value may vary due to
different device capabilities and frame rate setups. Please select
from the dropdown list.
5.8.5.3 Video Matrix
The interface is shown as in Figure 5-102.
Here you can set video output channel and interval.
To Next Page
Loading...
