Dahua DH-PFM88 Series - 7 Network Settings (Continued); Firewall Configuration Interface View; IP and MAC Filtering Rules Setup

60 pages

To Next Page

To Previous Page

Figure 7-3 Firewall

Filter one equipment whose IP address is xxx.xxx.xxx.xxx

Firewall is enabled, IP filtering mode is set to be “Refuse”, and any one item in IP1～IP10 is set to be IP

that shall be filtered.

Filter one equipment

Firewall is enabled, MAC filtering mode is set to be “Refuse”, and any one item in Mac1～Mac10 is set to

be MAC address of the equipment to be filtered.

Except the equipment whose IP address is xxx.xxx.xxx.xxx, others are filtered.

Choose to “Accept” IP filtering. Any one item in IP1～IP10 is set to be the IP that shall be accepted.

Accept only one equipment

Firewall is enabled, MAC filtering mode is set to be “Accept”, and any one item in Mac1～Mac10 is set to

be MAC address of the equipment to be accepted.