Dahua DHI-ARC3008C - Page 24

Alarm Control Panel Installer Manual
23
Key
Function
Quick input. For example, if your type in 130, press

immediately to confirm the input, otherwise the input will become
invalid.
Quick jump. For example, if there are 300 logs and you want to view

the 200th log, type in 200, and then press immediately to
jump to the 200th log page.
Increase or decrease numbers.

Switch options on the interface.

Page turning.

Enter the sub menu.

Switch to the next menu of the same level in editing mode.

Confirm the input.

Arm the whole Area.

Rapid Total Arming to the whole Area.

Give combination operations. For details, see Table 1-7.

Arm the PARTITION 1.

Rapid Arming the PARTITION 1.

Give combination operations. For details, see Table 1-7.

Arm the PARTITION 2.

Rapid Arming the PARTITION 2.

Give combination operations. For details, see Table 1-7.

Disarm.

Move the pointer to the right when you edit number or letter.

1.15.3 Key Combination Operations
How to press key combination: Press in sequence.
For example, if you need to press + 0, press first, and then press 0.
Table 1-7 Key combinations
Key
Function
+ 0 (F0)
On the main interface, press + 0 (F0) to show the GSM and
wireless signal strength. The GSM signal is shown with eight bars, and
the wireless signal is shown with four bars.
Press + 0 (F0) again to return to the main interface. Without
pressing + 0 (F0), the system automatically returns to the main
interface in 2 min if no operations were performed.