Alarm Control Panel Installer Manual
34
Press to return to the POWER SUPPLIES menu. Step 4
Then you can press and to move to the next menu or press to exit from the
Installer Menu.
WIRED ZONES 1.24
After entering the Installer Menu, press and to scroll up and down until you reach the Step 1
WIRED ZONES menu. See Figure 1-20.
Wired zones Figure 1-20
Press to enter the programming mode. Step 2
By pressing + 2, you can enter the EDITING mode for changing the description of wired
zone.
Press and to select the wired zone that you want to configure, and then press . Step 3
Configure the settings for the selected wired zone. See Table 1-13. Step 4
To Next Page
Loading...
