20
Table 3-6 Network parameters description
Parameter Description
Net Mode
The default setting is multi-address for 1-channel 4K high definition
(H.265) series, and fault tolerance for other models.
MAC Address Configure MAC address.
Network Device Name It is Bond1 by default.
Default Network Card Only 1-channel 4K high definition (H.265) series can set the parameter.
IP Version It is IPv4 by default.
IP Address
Enter numbers to change the IP address, and then configure its Subnet
Mask and Gateway.
Subnet Mask
Gateway
DHCP
Select the DHCP box, the system automatically obtains an IP address.
When the DHCP
function is enabled, the IP address, gateway, and
subnet mask cannot be set manually.
If DHCP is effective, the obtained information will be displayed in
the IP Address box, Subnet Mask box and Gateway box. If DHCP
is not effective, they all display 0.
To view manually set IP when DHCP is not effective, you shall
disable DHCP first, and then the device will display IP info that is
not obtained through DHCP. If DHCP is effective, and then DHCP is
disabled, static IP information will restore default settings. You need
to configure IP again.
When PPPoE is enabled, IP address, subnet mask, gateway and
DHCP cannot be changed.
Subnet Mask Enter subnet mask and gateway corresponding to the IP address.
IP address and gateway must be in the same network segment.
Gateway
TCP Port It is 37777 by default. You can configure port.
HTTP Port It is 80 by default. You can configure port.
UDP Port It is 37778 by default. You can configure port.
Max Connection
Connection is 0 to 128. If it is 0, no network user connection is allowed.
Max connection is 128.
Preferred
DNS/Alternate DNS
Configure the address of DNS server.
Click Save. Step 3
3.3.5 BPS
Only 1-channel 4K high definition (H.265) series support BPS.
Display real-time channel status, resolution and frame rate information.
In the main menu, select BPS. The BPS interface is displayed.
To Next Page
Loading...