54
4.5.1.2 User Management
User management adopts two-level management mode: user and user group. You can manage their
basic information (only those with user management authority can operate user management).
User name and group name support maximum 6 characters and can only be consisted of letter,
number, and underline (_).
The password can be set from 8 through 32 non-empty characters and contains at least two
types from capital letter, lower-case letter, number, and special characters (excluding "'", """, ";", ":"
and "&"). The user with authority can modify his/her own password, but also modify the
password of other users.
According to factory defaults, maximum user quantity is 64, while maximum user group
quantity is 20.
There are two-level management modes: user and user group. Group name and user name shall
be unique. One user can only belong to one group.
Current user cannot modify his/her own authority.
During initialization, there is 1 default user— admin. Admin is defined as high-authority user
when leaving factory.
4.5.1.2.1 User
You can manage user information. Add, modify and delete user, modify user password.
The Authority list is different depending on device model. The actual interface shall prevail.
Select Setup > System Config > User Management > User Management > User. The User
interface is displayed.
User Figure 4-42
Adding User
Add one user to the group, and configure user authority control.
As default user with the highest authority, admin cannot be deleted.
Click Add User. Step 1
The Add User interface is displayed.
To Next Page
Loading...