60
4.5.1.7.2 Close Buzzer
You can configure buzzer time. In case of alarm, the system will beep continuously according to the
set time. You can close buzzer according to your need.
Select Setup > System Config > Fan Control > Close Buzzer. Step 1
The Close Buzzer interface is displayed.
Fan control–Close Buzzer Figure 4-51
Configure time setup. Step 2
Click OK. Step 3
Click Close Buzzer to close the buzzer alarm function.
4.5.1.8 Comm Setup
After comm parameters are set, the network video decoder can connect other devices through
comm ports, for the purpose of debugging and operation.
1-channel 4K high definition (H.265) series does not support this function.
Select Setup > System Config > Comm Setup. Step 1
The Comm Setup interface is displayed.
Comm setup Figure 4-52
To Next Page
Loading...