62
It can be configured only in Network Access type.
Trusted list and restricted list can be configured in the same way. Take trusted list for
example.
1) Select Trusted List in Mode.
2) Click Add.
The Add interface is displayed.
Add Figure 4-54
3) Select Type, and then configure IP, Start Port and End Port.
Type supports IP, IP Segment and MAC Address. Configure parameters according to
actual situation.
4) Click OK.
The added device IP/MAC is displayed.
Added Figure 4-55
Click to edit device information.
Click to delete the device.
Click OK. Step 5
The system prompts "Saved successfully".
Click Refresh. The system prompts that "Operation is successful", and the interface is
refreshed.
4.5.1.9.2 System Service
Select the system service you want to enable.
Select Setup > System Config > Security Management > System Service. Step 1
The System Service interface is displayed.
To Next Page
Loading...