68
Parameter Description
Mode
Static
Manually enter the IP address, subnet mask and gateway.
DHCP
Select the DHCP box, the system automatically obtains an IP address.
When the DHCP function is enabled, the IP address, subnet mask and
default gateway cannot be set manually.
If DHCP is effective, the obtained information will be displayed in
the IP Address box, Subnet Mask box and Default Gateway
box. If DHCP is not effective, they all display 0.
To view manually set IP when DHCP is not effective, you shall
disable DHCP first, and then the device will display IP info that is
not obtained through DHCP. If DHCP is effective,
disabled, static IP information will restore default settings. You
need to configure IP again.
IP Address
Enter numbers to change the IP address, and then configure its Subnet
Mask and Default Gateway.
IP address and default gateway must be in the same network segment.
Subnet Mask
Default Gateway
Click OK to complete modification of net card information. Step 4
Click OK. Step 5
4.5.2.2 Port
Set max connection and port number to visit network video decoder through client (including web
client and PC client).
Select Setup > Network > Port > Connection Setup. Step 1
The Connection Setup interface is displayed.
Connection setup Figure 4-64
Configure max connection and port number. Step 2
Table 4-14 Port parameters description
Parameter Description
Max Connection
The allowable maximum number of clients accessing the Device at the same
time, such as web, platform, and mobile phone. The default value is 128.
TCP Port
TCP service port. The default setting is 37777. You can configure this
parameter.
To Next Page
Loading...