69
Parameter Description
UDP Port
User Datagram Protocol port. The default value setting is 37778. You can enter
the value.
HTTP Port
Hyper Text Transfer Protocol port. The default setting is 80. You can enter the
value, and in this case, please add the modified port number after the address
when logging the Device on the browser.
Click OK. Step 3
Except Max Connection, modifications of other parameters will take effect after reboot.
4.5.2.3 Sync IP
Sync IP adds IP of a device with timing function, to synchronize system time, and ensure the system
time is correct.
Select Setup > Network > Sync IP. Step 1
The Sync IP interface is displayed.
Sync IP Figure 4-65
Enter IP address, and then click Add. Step 2
Click OK. Step 3
4.5.3 Event Management
Manage abnormal events. The system executes alarm linkage actions according to settings.
4.5.3.1 Alarm Setup
You can configure local alarm and alarm output.
4.5.3.1.1 Local Alarm
Configure local alarm. When an abnormal event occurs, the system executes alarm linkage actions.
Select Setup > Event Management > Alarm Setup > Local Alarm. Step 1
The Local Alarm interface is displayed.
To Next Page
Loading...