75
Manual add Figure 4-74
Configure the parameters. Step 2
Table 4-17 Manual add parameters description
Parameter Description
Device Name It is to fill in device name.
Manufacturer Select device manufacturer.
Protocol It is TCP by default.
IP Address Configure the IP address of device to be added.
Port
Configure port number of device to be added. The port number is
37777 by default.
Username Configure the username to log in the device to be added.
Password Configure the password to log in the device to be added.
Channel No. Number of connected channels.
Click OK. Step 3
This network signal is displayed in the list, and the system displays Saved successfully.
Import and Export Config
Import and export configurations to add network signals in batches.
Enable HTTPS before using Import Config and Export Config functions. See "4.5.2.2 Port".
Import or export configurations. Step 1
Click Import Config, to import the preset devices information into the system.
Click Export Config, to export configuration file and save it in local device for backup.
Click Import Config or Export Config in HTTP environment. Step 2
A dialog box is displayed.
To Next Page
Loading...