User’s Manual
11
System
Configure the parameters.
Table 4-4 System parameter description
Parameter Description
Date Format
Select a format as needed.
Time Format
System Time
Changing system time might cause problems on video searching and information
publication. Turn off video recording and auto snapshot before changing it.
Time Zone
Configure the time zone as needed.
Sync with PC Synchronize the VTO system time with your PC.
DST
Daylight saving time. If it is applicable to your area, you need to enable it, and
then configure DST type, start time and end time.
DST Type
Select Date or Week as needed, and then configure the specific period.
Start Time
Configure the start time and end time of DST.
End Time
NTP Enable
Enable NTP and enter the IP address of the NTP server, and then the VTO will
syncronize time with the NTP server automatically.
NTP Server
Port NTP server port number.
Interval VTO time update cycle. 30 minutes at most.
Maintenance Define the time when the VTO will restrart automatically.
SSH
You can connect debugging devices to the VTO through SSH protocol.
We recommend turning it off, and turn on security mode and outbound service
information protection. See "4.5 Security". Otherwise, the VTO might be exposed
to security risks and data leakage.
Emergency
Maintenance
Enable it for fault analysis and repair.
To Next Page
Loading...
