User’s Manual
25
6 Network
This chapter introduces how to configure the network parameters.
Basic
6.1.1 TCP/IP
You can modify the IP address, subnet mask, default gateway, and DNS of the VTO.
Select Network > Basic.
TCP/IP and port
Configure the parameters, and then click Save.
The VTO will restart, and you need to modify the IP address of your PC to the same network
segment as the VTO to log in again.
6.1.2 Port
Table 6-1 Parameter description
Parameter Description
Port
80 by default. If already used, choose any number from 1025 to 65535 as
needed. You can enter http://VTO IP address:Port to log in to the VTO.
To Next Page
Loading...
