Daikin BRC1H61W - Page 8

7
Determining the wire routing direction for the back plate
Before mounting the controller, determine the wiring direction and remove a piece of the
controller’s back plate accordingly (i.e.: a, b, c). The wiring can be routed from the top, the
left, or the bottom of the back cover. Remove a piece of the back plate according to the
following gure.
After removing a thin piece with a tool such as clippers, remove burrs using a le, etc.
a Wiring from top
b Wiring from left
c Wiring from bottom
a
b
c
CAUTION
In case you are routing the wiring from the rear, you don’t have to remove anything.
When routing the wiring from the top, rear, left, or bottom, be sure to route the wiring to the upper
casing before securing the back plate.
01_EN_3P607378-2B_IM-K.indd 7 2020/07/28 11:39:51