3 | Components
Service manual
253
EBLA09~16DA + EDLA09~16DA
Daikin Altherma 3 M
ESIE20-06A – 2021.03
To install the thermistor
1 Install the thermistor in the thermistor holder as follows:
▪ For air (ambient) thermistor:
Correctly install the thermistor in the holder and close the thermistor holder.
▪ For refrigerant piping thermistors:
Pull the clip and install the thermistor in the specific thermistor holder. Make
sure the clip is in the correct position (blocking the thermistor).
a Clip
b Thermistor
c Thermistor holder
d Insulation
e Thermistor wire
f Tie strap
2 Route the thermistor harness towards the appropriate PCB.
3 Connect the thermistor connector to the appropriate PCB.
To Next Page
Loading...
