Do you have a question about the Daikin EDLA14DAW1 and is the answer not in the manual?
Model | EDLA14DAW1 |
---|---|
Category | Heat Pump |
Type | Split System |
Energy Efficiency Ratio (EER) | 11.5 |
Voltage | 208/230 V |
Power Supply | 1 Phase, 60 Hz |
Cooling Capacity | 14000 BTU/h |
Refrigerant | R410A |
Noise Level (Indoor Unit) | 40 dB |
Explains how to access short and long descriptions of malfunctions on the screen.
Details how to access and view the history of recent malfunctions.
Provides guidance on troubleshooting specific error codes, starting with 7H-01.
Details troubleshooting steps for water flow issues triggering the 7H-01 error code.
Troubleshooting for backup heater overheating due to activated thermal protector (AA-01 error).
Troubleshooting for main PCB detecting abnormal EEPROM data (E1-00 error).
Troubleshooting for refrigerant shortage detection, leading to unit stop (U0-00 error).
Troubleshooting for communication failures between indoor and outdoor units (U4-00 error).
Troubleshooting specific symptoms like incorrect energy metering or water pump issues.
Troubleshooting steps when the compressor fails to start, possibly due to low water loop temperature.
Troubleshooting steps when the system fails to start or operate, related to thermostat conditions.
Troubleshooting for a blocked water pump, possibly due to lime build-up.
Details checking procedures for the 3-way valve, including mechanical and electrical checks.
Details checking procedures for the 4-way valve, including mechanical and electrical checks.
Details checking procedures for the built-in backup heater, including resistance and insulation checks.
Details checking procedures for the hydro PCB, including power checks and HAP LED status.
Details checking procedures for the main PCB, including power checks, HAP LED, and spare part verification.
Details checking procedures for the refrigerant circuit, including stop valves and potential clogging.
Details the process and tools required for refrigerant recovery before servicing.
Procedure for performing refrigerant pump down operation before unit relocation.