Daikin FTXA20A2V1BW - Page 13

4 Operation
Operation manual
13
(C)(F)TXA15~50A2V1B(W)(S)(T)
Daikin room air conditioner
3P485919-7C – 2017.12
…lamp is blinking. Status
Operation and timer Communication is OFF
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless adapter to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button on the router (if present).
▪ SSID and KEY number on the unit.
To connect using the WPS button
1 Press for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Keep pressing or until the WPS setting display
(menu ) appears.
3 Press to confirm the selection.
Result: is blinking.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
Result: The timer LED is blinking.
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 Press for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Keep pressing or until the WPS setting display
(menu ) appears.
3 Press to confirm the selection.
Result: is blinking.
4 Open the Daikin Online Controller application and follow the
steps on the screen.
Result: The timer LED is blinking.
To connect the wireless adapter to your device
directly
1 Press for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Keep pressing or until the AP setting display (menu )
appears.
3 Press to confirm the selection.
Result: is blinking.
4 Connect with your smart device to the access point in the same
way as to a standard wireless network.
5 Enter the SSID number and password on the unit or in the
accessory set.
Result: The operation and timer LEDs are blinking.
6 Press to exit the menu.
Result: The display will return to the default screen.
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ switch between the WPS and the AP connection option,
▪ disconnect the Wi-Fi adapter and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 Press for at least 5seconds in the default screen.
Result: The confirmation display(menu ) appears.
2 Keep pressing or until the A display (menu )
appears.
3 Hold for at least 2seconds to confirm the selection.
Result: is blinking. The setting is reset to the factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless connection
You can turn off the wireless connection using:
▪ the user interface,
▪ the wireless adapter ON/OFF button on the unit.
To use the wireless adapter ON/OFF switch
1 Press the wireless adapter ON/OFF switch.
Result: The wireless adapter communication is OFF.
Note: Press the ON/OFF switch again to turn on the wireless
adapter.
To use the user interface
1 Press for at least 5seconds in the default screen.