Daikin FTXA20B2V1BS - To Operate the User Interface; Before Operation 4; To Fix the User Interface to the Wall; To Insert the Batteries

3 Before operation
Operation manual
4
CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
3P485919-7P – 2019.10
2.2.2 To operate the user interface
a
≥500
(mm)
a Signal receiver
Note: Make sure that there are no obstacles within 500mm under
the signal receiver. They may influence reception performance of the
user interface.
1 Aim the signal transmitter at the signal receiver on the indoor
unit (maximum distance for communication is 7m).
Result: When the indoor unit receives a signal from the user
interface, you will hear a sound:
Sound Description
Beep-beep Operation starts.
Beep Setting changes.
Long beep Operation stops.
3 Before operation
3.1 To fix the user interface to the wall
cba
2×
a User interface
b Screws (field supply)
c User interface holder
1 Choose a place where the signals reach the unit.
2 Attach the holder with screws to the wall or a similar location.
3 Hang the user interface on the user interface holder.
3.2 To insert the batteries
The batteries will last for about 1 year.
1 Remove the front cover.
2 Insert both batteries at once.
3 Put back the front cover.
2
3
1
AAA.LR03
INFORMATION
▪ Low energy of battery is indicated by flashing of LCD
display.
▪ ALWAYS replace both batteries at once.
3.3 About the clock
If the indoor unit's internal clock is NOT set to the correct time, the
ON timer, OFF timer and weekly timer will NOT operate correctly.
The clock must be set again:
▪ After a circuit breaker has turned the unit OFF.
▪ After a power failure.
▪ After replacing batteries in the user interface.
3.3.1 To set the clock
Note: If the time is NOT set, , , and blink.
1 Press .
Result: and blink
2 Press or to set the current day of the week.
Note: Holding down or increases or decreases the time
setting rapidly.
3 Press .
Result: blinks.
4 Press or to set the correct time.
5 Press .
Result: Setting is complete. blinks.
3.4 Brightness of the indoor unit
display
Adjust the brightness of the indoor unit display as desired, or turn
OFF the display.
3.4.1 To set the brightness of the indoor unit
display
1 Press for at least 2seconds.
Result: The menu appears on the display. is blinking.
2 Press .
3 Press or to change the setting as follows: