Daikin FTXA20B2V1BS - Page 35

5 | Operation
User reference guide
35
CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
4P518786-1F – 2020.05
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the AP mode display (menu ) appears.
3 Press to confirm the selection.
Result: is blinking. The operation and timer LEDs are blinking alternately.
4 Connect your smart device to the access point in the same way as to a
standard wireless network.
5 Enter the SSID number and password located on the unit or in the accessory
set.
6 Open the Daikin Online Controller application and follow the steps on the
screen.
Result: Wireless adapter mode will automatically change from the AP mode to
the RUN mode, the timer LED is blinking.
7 Press to exit the menu.
Result: The display will return to the default screen.
To reset the connection setting to the factory default
Reset the connection setting to the factory default in case you want to:
▪ switch between the WPS and the AP connection option,
▪ disconnect the Wi-Fi adapter and the communication device (e.g. router) or
smart device,
▪ repeat the setting if the connection was unsuccessful.
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display(menu ) appears.
2 Press repeatedly or until the A display (menu ) appears.
3 Hold for at least 2seconds to confirm the selection.
Result: is blinking. The setting is reset to the factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.