Daikin FTXA25B2V1BT - Page 12

4 Operation
Operation manual
12
CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
3P485919-7P – 2019.10
To connect the wireless adapter to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button on the router (if present),
▪ SSID and KEY number located on the unit.
To connect using the WPS button
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the WPS setting display
(menu ) appears.
3 Press to confirm the selection.
Result: is blinking. The timer LED is blinking.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
INFORMATION
If the connection with your router is not possible, try
procedure "To connect using SSID and KEY
number"[412].
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the AP mode display (menu
) appears.
3 Press to confirm the selection.
Result: is blinking. The operation and timer LEDs are blinking
alternately.
4 Connect your smart device to the access point in the same way
as to a standard wireless network.
5 Enter the SSID number and password located on the unit or in
the accessory set.
6 Open the Daikin Online Controller application and follow the
steps on the screen.
Result: Wireless adapter mode will automatically change from
the AP mode to the RUN mode, the timer LED is blinking.
7 Press to exit the menu.
Result: The display will return to the default screen.
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ switch between the WPS and the AP connection option,
▪ disconnect the Wi-Fi adapter and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display(menu ) appears.
2 Press repeatedly or until the A display (menu )
appears.
3 Hold for at least 2seconds to confirm the selection.
Result: is blinking. The setting is reset to the factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless connection
You can turn off the wireless connection using:
▪ the wireless adapter ON/OFF button on the unit,
▪ the user interface.
To use the wireless adapter ON/OFF switch
1 Press the wireless adapter ON/OFF switch.
Result: The wireless adapter communication is OFF.
Note: Press the ON/OFF switch again to turn on the wireless
adapter.
To use the user interface
1 Hold for at least 5seconds in the default screen.
Result: The confirmation display (menu ) appears.
2 Press repeatedly or until the OFF menu appears.
3 Hold for at least 2seconds to confirm the selection.
Result: is blinking. Communication is OFF.
4 Press to exit the menu.
Result: The display will return to the default screen.