Daikin FTXA25B2V1BT - Troubleshooting for Wireless Connection Adapter

8 | Troubleshooting
User reference guide
51
CTXA15+FTXA25~50(A)(B)2V1B(W)(S)(T)(B)
Daikin room air conditioner
4P518786-1F – 2020.05
8.3 Troubleshooting for wireless connection adapter
The following table provides a brief description of how to deal with some
problems. If none of the following solutions fix the problem, go to http://
www.onlinecontroller.daikineurope.com/ for more information and FAQ.
Problem Measure
Connection to the WLAN adapter is not
possible (none of the LEDs are blinking).
▪ Try operating the unit with the user
interface.
▪ Check if the power is on.
▪ Turn the unit off and back on again.
The WLAN adapter is NOT visible on the
unit overview screen (Home screen)
after configuration of the WLAN
adapter (WPS option).
▪ Make sure the wireless LAN adapter is
close enough to the communication
device.
▪ Check if communication is OK.
▪ Make sure that the smart device is
connected to the same wireless
network as the WLAN adapter.
▪ Try resetting to the factory default
and repeat the setting. See "To reset
the connection setting to the factory
default"[435].
The WLAN adapter is NOT visible in the
available Wi-Fi networks list on the
smart device (Access point option).
▪ Try switching between access point
and WPS setting to change the
wireless channel. The wireless
channel MUST be between 1~11.
▪ Check if communication is OK.
▪ Try resetting to the factory default
and repeat the setting. See "To reset
the connection setting to the factory
default"[435].
Displayed indoor/outdoor temperature/
humidity value in Online Controller
differs from the value measured by
other appliances.
▪ Online Controller displays indoor/
outdoor temperature/ humidity only
for the indoor/outdoor unit's
surrounding.
▪ Measured temperature/humidity for
other appliances may differ due to
different condition around the unit
(e.g. direct sunlight, frost
accumulation…)
▪ Temperature/humidity displayed in
Online Controller is only referential.