20
Care and Cleaning
3-2 Titanium apatite photocatalytic air-purifying lter
The titanium apatite photocatalytic air-purifying lter can be renewed by washing it with
water once every 6 months. We recommend replacing it once every 3 years.
[Maintenance]
3-2-1 Vacuum dusts, and soak in warm water
or water for about 10 to 15 minutes if dirt
is heavy.
• Do not remove the lter from frame when
washing with water.
3-2-2 After washing, shake off remaining water
and dry in the shade.
• Since the material is made out of
polyester, do not wring out the lter when
removing water from it.
[Replacement]
3-2-3 Remove the tabs on the lter frame and
replace with a new lter.
• Do not throw away the lter frame. Reuse
the lter frame when replacing the
titanium apatite photocatalytic air-
purifying lter.
• Dispose of the old lter as non-ammable
waste.
4. Set the air lter and titanium apatite
photocatalytic air-purifying lter as they
were and close the front panel.
• Insert claws of the lters into slots of the front panel.
Close the front panel slowly and push the panel at
the 3 points. (One on each side and one in the
middle.)
NOTE
• Operation with dirty lters:
(1) cannot deodorise the air. (2) cannot clean the air.
(3) results in poor heating or cooling. (4) may cause odour.
• To order titanium apatite photocatalytic air-purifying lter contact to the service shop there you
bought the air conditioner.
• Dispose of the old lter as non-ammable waste.
Item Part No.
Titanium apatite photocatalytic air-purifying lter
(without frame) 1 set
KAF970A46
To Next Page
Loading...
