Daikin FTXB20C2V1B - Indoor Unit; Outdoor Unit

5
 Outdoor Unit
• Appearance of the outdoor unit may differ from some models.
 Indoor Unit
1a. Air lter
1b. Titanium apatite photocatalytic air-
purifying lter:
• These lters are attached to the inside of
the air lters.
2. Model name plate
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the
unit.
7. Display
8. Air outlet
9. Flap (horizontal blade): (page 11)
10. Louvers (vertical blades):
• The louvers are inside of the air outlet.
(page 12)
11. Signal receiver:
•
It receives signals from the remote controller.
• When the unit receives a signal, you will
hear a beep sound.
• Operation start .............beep-beep
• Settings changed .........beep
• Operation stop .............long beep
12. OPERATION lamp (green)
13. TIMER lamp (yellow): (page 16)
14. Indoor unit ON/OFF switch:
• Press this switch once to start operation.
Press once again to stop it.
• The operation mode refers to the following
table.
Mode
Temperature
setting
Airow rate
AUTO 25°C AUTO
• This switch is useful when the remote
controller is missing
 Outdoor Unit
15. Air inlet (back and side)
16. Air outlet
17. Refrigerant piping and inter-unit wiring
18. Drain hose
19. Earth terminal:
• It is inside of this cover.