17
ON TIMER Operation
To use ON TIMER operation
1. Press .
“ ” is displayed on the LCD.
Each pressing of advances the time setting by 1 hour.
The time can be set between 1 to 12 hours.
• The TIMER lamp lights up.
To cancel ON TIMER operation
2. Press .
• “ ” disappears from the LCD.
• The TIMER lamp goes off.
To combine ON TIMER and OFF TIMER
• A sample setting for combining the 2 timers is shown below.
• “
” and “ ” are displayed on the LCD.
Display
NOTE
In the following cases, set the timer again.
• After a breaker has turned off.
• After a power failure.
• After replacing batteries in the remote controller.
To Next Page
Loading...
