Service Check Function SiUS041111
76 Service Diagnosis
Check Method 2
1. Press the 3 buttons (TEMP, TEMP, MODE) simultaneously to enter the diagnosis mode.
The left-side number blinks.
2. Press the TEMP
or button and change the figure until you hear the beep(s).
3. Diagnose by the sound.
beep : The left-side number does not correspond with the error code.
beep beep : The left-side number corresponds with the error code but the right-side number
does not.
long beep : Both the left-side and right-side numbers correspond with the error code.
Error codes and description Refer to page 78.
4. Press the MODE button.
The right-side number blinks.
To Next Page
Loading...
