6
1 Press and hold down at the
same time for 5 seconds while the
Celsius temperature is indicated.
Preparation before Operation
2 Press and hold down at the
same time for 5 seconds while
the Fahrenheit temperature is
indicated.
Setting Temperature Indication change
Temperature indication can be changed between Celsius and Fahrenheit before use.
1·2
Notes
Temperature indication change between Celsius and Fahrenheit on the remote controller
Change the temperature indication in the modes other than the DRY mode.
In the DRY mode, temperature indication setting cannot be changed because the temperature is not indicated.
When the Fahrenheit temperature indication is changed to Celsius one, the temperature value
(0.5˚C) will be rounded up. Thus, the preset temperature may be changed.
Example:
A preset temperature of 65˚F (equivalent to 18.5˚C) will be changed to 19˚C (66˚F) b y changing the temperature indication.
In this case, if you change the Celsius temperature indication again to the Fahrenheit one, the preset temperature is shown not as 65˚F but
as 66˚F (equivalent to 19˚C). If the preset temperature is 66˚F (equivalent to 19˚C) and is changed to the Celsius temperature indication,
the indication becomes 19˚C (66˚F). In this case, no change by the temperature indication change is observed.
When the temperature indication change is set, the preset temperature is transmitted to the
indoor unit so that the reception sound will be heard from the indoor unit.
To change from Celsius temperature
indication to Fahrenheit one
To change from Fahrenheit
temperature indication to Celsius one
To Next Page
Loading...
