Si041553EB Electrical Box / Swing Motor
Removal Procedure 7
3 Pull out the indoor heat
exchanger thermistor.
Be careful not to lose the clip
of the thermistor.
When reassembling, pass
the indoor heat exchanger
thermistor behind the green
earth/ground wire.
4 Release the thermistor
harness from the slit at
the top of the electrical
box.
5 Unfasten the 4 hooks
and remove the
electrical box cover.
When reassembling, make
sure the 4 hooks are
securely fastened.
Step Procedure Points
Indoor heat
exchanger
thermistor
(R21505)
Clip
(R11268)
Thermistor harness Electrical box
Thermistor
harness
Slit
(R24273)
Electrical box
cover
Hook
Hook
Hook
(R21508)
When reassembling, be
sure to insert the thermistor
harness in the slit as shown
in the picture.
To Next Page
Loading...
