5
English
Outdoor Unit
Appearance of the outdoor unit may differ from some models.•
17
18
19
20
16
22
21
Indoor Unit
Air fi lter 1.
Titanium apatite photocatalytic 2.
air-purifying fi lter:
These fi lters are attached to the inside of •
the air fi lters.
Air inlet3.
Front panel4.
Panel tab5.
Room temperature sensor:6.
It senses the air temperature around the •
unit.
Display7.
Air outlet8.
Flap (horizontal blade): 9. (page 11)
Louvers (vertical blades):10.
The louvers are inside of the air outlet. •
(page 12)
Model name plate11.
Indoor unit ON/OFF switch:12.
Press this switch once to start operation. •
Press once again to stop it.
The operation mode refers to the following •
table.
Mode
Temperature
setting
Airfl ow rate
AUTO 25°C AUTO
This switch is useful when the remote •
controller is missing.
OPERATION lamp (green)13.
TIMER lamp (yellow): 14. (page 14)
Signal receiver:15.
It receives signals from the remote controller.
•
When the unit receives a signal, you will •
hear a beep sound.
Operation start• .............beep-beep
Settings changed• .........beep
Operation stop• .............long beep
Outdoor Unit
Air inlet (back and side)16.
Refrigerant piping and inter-unit wiring17.
Drain hose18.
Earth terminal:19.
It is inside of this cover.•
Air outlet20.
Outdoor temperature sensor (back)21.
Model name plate22.
01_EN_3P276856-1B.indb 501_EN_3P276856-1B.indb 5 12/20/2010 4:17:11 PM12/20/2010 4:17:11 PM
To Next Page
Loading...
