Installation and Operation EDUS39-800-F9_a
34 FXZQ-M
17. WIRING DIAGRAM
A1P ..........................PRINTED CIRCUIT BOARD
C1.............................CAPACITOR (M1F)
F1U ..........................FUSE (B, 5 A, 250 V)
HAP..........................LIGHT EMITTING DIODE (SERVICE MONITOR - GREEN)
KPR..........................MAGNETIC RELAY (M1P)
M1F ..........................MOTOR (INDOOR FAN)
M1P..........................MOTOR (DRAIN PUMP)
M1S..........................MOTOR (SWING FLAP)
Q1M .........................THERMAL PROTECTOR (M1F EMBEDDED)
R1T ..........................THERMISTOR (AIR)
R2T ..........................THERMISTOR (COIL LIQUID)
R3T ..........................THERMISTOR (COIL GAS)
S1L...........................FLOAT SWITCH
T1R ..........................TRANSFORMER (208~230 V/22 V)
V1TR ........................ PHASE CONTROL CIRCUIT (TRIAC)
X1M,X2M .................TERMINAL BLOCK
Y1E ..........................ELECTRONIC EXPANSION VALVE
WIRED REMOTE CONTROLLER
R1T ..........................THERMISTOR (AIR)
SS1 ..........................SELECTOR SWITCH (MAIN/SUB)
RECEIVER/DISPLAY UNIT (ATTACHED TO WIRELESS REMOTE CONTROLLER)
A3P,A4P ................... PRINTED CIRCUIT BOARD
BS1 ..........................ON/OFF BUTTON
H1P ..........................LIGHT EMITTING DIODE (RED)
H2P ..........................LIGHT EMITTING DIODE (GREEN)
H3P ..........................LIGHT EMITTING DIODE (RED)
H4P ..........................LIGHT EMITTING DIODE (ORANGE)
SS1 ..........................SELECTOR SWITCH (MAIN/SUB)
SS2 ..........................SELECTOR SWITCH (WIRELESS ADDRESS SET)
CONNECTOR FOR OPTIONAL PARTS
X16A ........................CONNECTOR (ADAPTOR FOR WIRING)
X18A ........................CONNECTOR (ADAPTOR FOR ELECTRICAL APPENDICES)
POWER SUPPLY :
RECEIVER/DISPLAY UNIT :
WIRED REMOTE CONTROLLER :
CONTROL BOX :
INPUT FROM OUTSIDE :
TRANSMISSION WIRING :
CENTRAL REMOTE CONTROLLER :
1 WHEN USING THE CENTRAL REMOTE CONTROLLER, SEE INSTALLATION MANUAL FOR CONNECTION TO THE UINIT.
2 X23A IS CONNECTED WHEN THE WIRELESS REMOTE CONTROLLER IS USED.
3 WHEN CONNECTING THE INPUT WIRES FROM OUTSIDE, FORCED OFF OR ON/OFF CONTROL OPERATION CAN BE
SELECTED BY THE REMOTE CONTROLLER. SEE INSTALLATION MANUAL FOR MORE DETAILS.
4 REMOTE CONTROLLER VARIES ACCORDING TO THE COMBINATION SYSTEM. SEE TECHNICAL DATA AND CATALOGS,
ETC., BEFORE CONNECTING.
: FIELD WIRING BLK : BLACK PNK : PINK
: TERMINAL BLU : BLUE RED : RED
: CONNECTOR GRN : GREEN WHT : WHITE
ORG : ORANGE YLW : YELLOW
To Next Page
Loading...
